Notes

•When unplugging the AC power cord, ensure that the lens protector closes and the powered tilt adjuster is put away in the projector.

Moving the projector with the powered tilt adjuster rised may damage the adjuster.

•Turn off the projector according to the procedure in “Turning off the power”, then cool it down when storing the projector in the carrying case.

Direct Power On/Off Function

If you will be using a circuit breaker to turn the power for the entire system on and off, set the direct power on function to “On.” When you turn off the power, you can also just unplug the power cord without pressing the I / 1 key. The internal circuitry will cause the fan to automatically operate for a certain time even after the power cord is removed.

Note

However, if the unit has been on for less than 15 minutes, the fan might not begin to turn as a result of inadequate charging. In that case, follow the procedure for turning off the power as described in “Turning Off the Power” on page 22.

Effective Tools for YourPresentationTo enlarge the image (Digital Zoom function)

You can select a point in the image to enlarge. This function works when a signal from a computer is input.

This function does not work when a video signal is input.

1 Project a normal image, and press the D ZOOM + key on the Remote Commander.

The digital zoom icon appears in the center of the image.

GB 26 Other Functions

Digital zoom icon

2 Move the icon to the point on the image you want to enlarge. Use the arrow key (M/m/</,) to move the icon.

3 Press the D ZOOM + key again.

The image where the icon is located is enlarged. The enlargement ratio is displayed on the screen for a few seconds.

By pressing the + key repeatedly, the image size increases (ratio of enlargement: max. 4 times.)

Use the arrow key (M/m/</,) to scroll the enlarged image.

To return the image back to its original size

Press the D ZOOM – key.

Just pressing the RESET key returns the image back to its original size immediately.

To freeze the image projected (Freeze function)

Press the FREEZE key. “Freeze” appears when the key is pressed. This function works when a signal from a computer is input.

To restore the original screen, press the FREEZE key again.