The INSTALL

SETTING Menu

The INSTALL SETTING menu is used for changing the settings of the projector.

INSTALL SETTING

Input-A

T i l t . . .

 

V Keystone:

Auto

Side Shot:

0

Imag e Flip:

Off

Background:

Blue

Test Pattern:

Off

Lamp M ode:

Standard

Lens Control:

On

Direct Power On: Off

High Altitude Mode: Off

Security Lock: Off

Menu Items

Tilt...

Adjusts the position (height) of the projected picture. Pressing the f on the TILT adjustment key or M/, key on the Remote Commander, the more the projector tilts and the higher the position of the picture. Pressing the F on the TILT adjustment key or m/< key on the Remote Commander, the less the projector tilts and the lower the position of the picture.

V Keystone

Corrects the trapezoidal distortion caused by the projection angle. Select “Auto” for automatic correction, or “Manual” for manual correction using the < or , key.

When the bottom of the trapezoid islonger than the top : Sets a lower value.When the top of the trapezoid is longerthan the bottom : Sets a higher value.

Note

The auto V Keystone adjustment may not correct the trapezoidal distortion perfectly, depending on the room temperature or the screen angle.

Side Shot

Corrects the horizontal trapezoidal distortion of the picture using the < or , key on the Remote Commander.

When the right side is longer than the left side ( )

Set to a higher value (+ direction).

When the left side is longer than the right side ( )

Set to a lower value (– direction).

Set the adjustment level to “0” if you want to adjust the picture more widely using “V Keystone” only.

Note

Even when projecting using “Side Shot”, the four sides of a picture may sometimes not be parallel to the respective sides of a screen frame.

Image Flip

Flips the image on the screen horizontally and/or vertically.

Off: The image does not flip.

HV: Flips the image horizontally and vertically.

H:Flips the image horizontally.

V:Flips the image vertically.

Background

Select the background color of the screen when no signal is input to the projector. Select “Black” or “Blue”.

Normally, set to “Blue.”

Test Pattern

The factory setting is “Off.”

When set to “On,” a test pattern is displayed on the screen during the “Lens Zoom” adjustment, “Lens Focus,” “Side Shot” or “V Keystone.” If you do not want to display a test pattern, set to “Off”.

Lamp Mode

Sets the lamp brightness in the projection.

Menu the Using Settings and Adjustments

The INSTALL SETTING Menu 35 GB