4 Turn the main power off and disconnect the AC power cord.

The security lock is set to on, then it becomes effective. The screen for entering the password is displayed when the power is turned on the next time.

Security certification

When the screen for entering the password is displayed, enter the password that was set. If you fail to enter the correct password after three tries, the projector cannot be used. In this case, press the I / 1 key to turn off the power.

To cancel the security lock

1 Press the MENU key, then turn off the “Security Lock” setting in the INSTALL SETTING menu.

2 Enter the password.

Enter the password that was set.

Note

If you call the customer service center because you have forgotten the password, you will need to be able to verify the projector’s serial number and your identity. (This process may differ in other countries.) Once your identity has been confirmed, we will provide you with the password.

Other Functions

Switching from the Intelligent Auto-setup Function to Manual Adjustments

You can switch the following functions of the Intelligent Auto-setup to manual adjustments using the menu.

•V Keystone correction (correction of trapezoidal distortion)

Set “V Keystone” in the INSTALL SETTING menu to “Manual.”

•Smart APA (Auto Pixel Alignment) Set “Smart APA” in the SET SETTING menu to “Off.”

•Auto Input Search

Set “Auto Input Search” in the SET SETTING menu to “Off.”

For details on the menu operations, see “Using the MENU” on page 27.

Controlling the ComputerUsing the Supplied RemoteCommander (When Using theUSB Cable)

When you connect a computer to the projector by using the USB cable, you can control the mouse of the computer using the Remote Commander.

The R/L CLICK keys and joystick function as follows.

Key and joystickFunction

 

 

R CLICK (front)

Right button

 

 

L CLICK (rear)

Left button

 

 

Joystick

Corresponds with the

 

movements of the

 

mouse

 

 

For details on USB connection, see “To connect a computer” on page 17.

Note

Make sure that nothing obstructs the infrared beam between the Remote Commander and the remote control detector on the projector.

Off & Go Function

If you are leaving the conference room immediately, turn the projector off, and then, after the lens protector closes and the powered tilt adjuster is put away in the projector, you can unplug the AC power cord. After the AC power cord is unplugged, the fan runs automatically.

Function Convenient

Other Functions 25 GB