4 Loosen the two screws on the lamp unit with the Phillips screwdriver (1). Fold out the handle (2), then pull out the lamp unit by the handle (3).

Handle

5 Insert the new lamp all the way in until it is securely in place (1). Tighten the two screws (2). Hold down the handle to replace (3).

•The power will not turn on if the lamp is not secured properly.

6 Close the lamp cover and tighten a screw.7 Turn the projector back over.8 Connect the power cord.

The ON/STANDBY indicator around the I/1 key lights in red.

9 Press the following keys on the Remote Commander in the following order for less than five seconds each: RESET, <, ,, ENTER.

Note

Do not put your hands into the lamp replacement spot, or not fall any liquid or object into it to avoid electrical shock or fire.

Disposal of the used lampFor the custmers in the USA

This product contains mercury. Disposal of this product may be regulated if sold in the United States. For disposal or recycling information, please contact your local authorities or Electronics Industries Alliance (www.eiae.org http://www.eiae.org).

Cleaning the Air Filter

The air filter should be cleaned every 1000 hours.

Remove dust from the outside of the ventilation holes with a vacuum cleaner.

1000 hours are approximate. This value varies depending on the environment or how the projector is used.

Notes

• Be careful not to touch the glass surface of the lamp.

GB 38 Maintenance