Sony VPL-CX80 2 Press the I / 1 key, 4 Press the INPUT key to select the input source, 3 Turn on the equipment connected to the projector, Notes, display, To input from

Projecting

2	4	5
	INPUT	TILT	MENU	PUSH
				ENTER
	ON/STANDBY indicators
				6
Rear remote				1
control
detector
	COMMAND		2
	OFF ON
	PIC
	PJ NETWORK MUTING
	AUDIO	INPUT	4
		TILT/KEYSTONE	5
	LENS
	VOLUME
	APA
	MENU/	AIR SHOT
	TAB
	FREEZE

1 Plug the AC power cord into a wall outlet, then connect all equipment.

The ON/STANDBY indicator lights in red and the projector goes into standby mode.

2 Press the I / 1 key.

The ON/STANDBY indicator lights in green and the Intelligent Auto-setup starts. The lens protector opens, and the powered tilt adjuster rises and stops at the previously adjusted position.

3 Turn on the equipment connected to the projector.4 Press the INPUT key to select the input source.

Each time you press the key, the input signal switches as follows:

INPUT-A t INPUT-B t VIDEO t S-VIDEO
t
To input from	Press INPUT to
	display
Computer connected to	INPUT-A
the INPUT A connector
Computer connected to	INPUT-B
the INPUT B connector
Video equipment	VIDEO
connected to the VIDEO
input connector
Video equipment	S-VIDEO
connected to the S VIDEO
input connector

Smart APA (Auto Pixel Alignment) adjusts the picture of the connected equipment so that it is projected clearly.

Notes

•If “Auto Input Search” is set to “On,” the projector searches for the signals from the connected equipment and displays the input channel where the input signals are found.

For details, see “Auto Input Search” on page 33.

•The Smart APA is effective for the input signal from a computer only.

5 Switch the equipment to be connected to output to the projector.

Depending on the type of your computer, for example a notebook, or an all-in-one LCD type, you may have to switch the computer to output to the projector by pressing certain keys

(e.g., LCD / VGA , / , etc.), or by

changing your computer’s settings.

GB 20 Projecting