Warning Indicators

The ON/STANDBY or LAMP/COVER indicator lights up or flashes if there is any trouble with your projector.

 

LAMP/COVER indicator

 

ON/STANDBY indicator

 

 

Symptom

Cause and Remedy

 

 

LAMP/COVER flashes in

c Close the lamp cover securely, then tighten the screws securely.

red. (A repetition rate of 2

(1 page 60)

flashes)

c Close the filter holder securely. (1 page 61)

 

 

LAMP/COVER flashes in

c The lamp has reached the end of its useful lifespan. Replace the

red. (A repetition rate of 3

lamp. (1 page 59)

flashes)

c The lamp has reached a high temperature. Wait until the lamp

 

cools, and then turn on the power again.

 

 

ON/STANDBY flashes in

c The fan is broken. Consult with qualified Sony personnel.

red. (A repetition rate of 4

 

flashes)

 

 

 

ON/STANDBY flashes in

c The internal temperature is unusually high. Check to ensure that

red. (A repetition rate of 2

if nothing is blocking the ventilation holes or whether or not the

flashes)

projector is being used at high altitudes.

 

 

ON/STANDBY flashes in

c Press the I/1 (ON/STANDBY) switch to turn on the projector. If

red. (A repetition rate of 6

the power is not turned on, disconnect the AC power cord, then

flashes)

confirm the ON/STANDBY lamp is turned off. After about 10

 

seconds, reconnect the AC power cord and turn on the power

 

again. If the indicators still light up, the electrical system has a

 

problem. Consult with qualified Sony personnel.

 

 

Note

When a warning indicator other than the above starts flashing, and the symptom persists even after carrying out the above methods, consult with qualified Sony personnel.

Others

57