Page
THIS APPARATUS MUST BE EARTHED
For customers in the USA
Declaration of Conformity
Disposal of Used Lamp
For customers in the United States
For customers in Europe
For kundene i Norge
Trademark Information
Page
Table of Contents
Location of Controls
Connections and
Preparations
Projecting
Others
On safety
On preventing internal heat buildup
Caution
On repacking
Location of Controls
Page
Page
Connections and Preparations
Before Setting Up the
Projector
Improper use
Do not do any of the following while using the projector
Blocking the ventilation holes (intake or exhaust)
Tip
Tilting front/rear and left/right
Positioning the Projector and a screen
When using the 16:9 aspect ratio screen size
When using the 4:3 aspect ratio screen size
2 Position the projector so that the lens is parallel to the screen
Top view
Connecting to a VCR
Page
To connect to a VCR equipped with the S video connector or video connector
Connecting to a Computer
Page
2 Press the ?/1 (ON/STANDBY) switch to turn on the projector
3 Turn on the equipment connected to the projector
4 Press INPUT to project the picture on the screen
5 Move both lens shift dials to adjust the picture position
To adjust the horizontal position
To adjust the vertical position
6 Adjust the picture size using the zoom lever
7 Adjust the focus using the focus ring
To adjust the tilt of the installation surface
1 Press MENU
2 Press M/m to select the Setup menu, and press , or
3 Press M/m to select “Language,” and press , or
4 Press M/m/</, to select a language, and press
To clear the menu
Projecting
Turning Off the Power
Press WIDE MODE
Wide Zoom
Normal
Full
Zoom
Full 1 (When a computer signal is input)
Full 2 (When a computer signal is input)
Notes on selecting the wide screen mode
Press one of the PICTURE MODE buttons
(DYNAMIC, STANDARD, CINEMA and USER 1, USER 2 and USER 3)
DYNAMIC
STANDARD
CINEMA
1 Press ADJ PIC
2 Make the setting or adjustment
on an item
When changing the adjustment
level
1 Press RCP on the remote control
2 Press M/m to select “User 1,” “User 2” or “User 3,” then press
3 Select the target color you want to adjust
4 Adjust the color of the specified portions
5 After the adjustment is complete, press
Press PIC MUTING
Press APA
Press FREEZE
Using the Menus
2 Press M/m to select a menu item, and press , or
,or
4 Make the setting or adjustment of an item
When changing the adjustment level
Items that cannot be adjusted
To reset the picture that has been adjusted
To reset the items that have been adjusted
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
About the Preset Memory No
Others
Power
Picture
On-screendisplay
Remote control
Others
Warning Indicators
Message Lists
Warning messages
Caution messages
Tools you need to get started:
•Projector Lamp LMP-H201(optional)
•Standard Phillips screwdriver
•Cloth (for scratch protection)
1 Turn off the projector and unplug the AC power cord
6Close the lamp cover, then tighten the screws
7Remove the filter holder
8Remove the air filter
10 Attach the filter holder
11 Wipe dust off the ventilation holes (intake) with a soft cloth
12 Place the project back on its
Page
Cleaning the lens
Cleaning the cabinet
Black points and bright points (red, blue, or green) on the screen
System
Input
General
Supplied accessories
Optional accessories
Preset Signals
Page
Preset memory numbers for each input signal
Analog signal
Digital signal
Input Signals and Adjustable/Setting Items
Screen menu
Page
Page
Attaching the PSS-H10projector suspension support
Top view
Front view
Side view
