Installation

Fitting the lens

1 Remove the lens mount cap.

2 Screw in the lens (not supplied), and turn it until it is secured.

Note

Clean the optical filter with a commercially available blower brush to remove dust.

Using a tripod

To use the tripod, install the VCT-ST70I tripod adaptor (not supplied) on the camera module.

Use a tripod screw with a protrusion ( ) extending from the installation surface, as follows:

ISO standard: Length 4.5 mm to 5.0 mm

ASA standard: Length 0.197 inches

Tighten the tripod screws using a hand screwdriver.

Note

When you install the tripod adaptor, use the screws supplied with the tripod adaptor.

1IEEE1394b connector2Fixing screws3IEEE1394b camera cable (not supplied)

Note

Loose fixing screws may cause a poor connection or damage to the camera or cable. Be sure to tighten the fixing screws.

When power supply from the IEEE1394b connector is insufficient

Power can be supplied to the camera module via the DC- 700/700CE camera adaptor (optional) and a camera cable such as CCXC-12P05N (optional) if power supply from the IEEE1394b connector is insufficient.

Overview

Connecting the camera cable

Connect a commercially available IEEE1394b camera cable to the IEEE1394b connector and the 1394b interface connector of your PC. When you connect the cable, insert the cable connector into the IEEE1394b connector until it snaps into place, holding it. Then, tighten the fixing screws placed on both sides of the cable connector.

112-pin I/O connector2Camera cable (e.g. CCXC-12P05N)3to AC power source4CAMERA connector5~ AC IN connector6Trigger generator

7