6a USER CONFIG 1 menu

Select an item to adjust on the menus and screens (!™ through !ª). To go to the USER CONFIG 2 menu, select NEXT PAGE.

6b USER CONFIG 2 menu

Select an item to adjust on the menus and screens (@º through @¢). To go to the USER CONFIG 1 menu select PREVIOUS PAGE.

7AUTO ADJUST screen

Select the color bar signal (full, SMPTE, EIA) and press ENTER/SELECT to start automatic “chroma” and “phase” (NTSC signal only) adjustments.

To activate these adjustments, select ON on the CHROMA SET UP menu (3).

8ADJUST GAIN screen

Adjust GAIN in USER mode.

9ADJUST BIAS screen

Adjust BIAS in USER mode.

!ºCOLOR TEMP RANGE menu

Select the color temperature range in USER mode. [5000K-10000K]

!¡USER COPY menu

Store the factory setting of D65 or D93 as the value for USER mode.

!™COLOR SYSTEM DISPLAY menu

Select the color system type. When AUTO is selected, the color system type being used appears on the screen

each time you change the signal input. [AUTO]

!£358 TRAP FILTER menu

Color spill or color noise may be eliminated if you select ON (NTSC signal only).

Normally select OFF.

[OFF]

!¢SUB CONTROL menu

Select an item (CONTRAST, BRIGHT, CHROMA and PHASE controls on the front panel) to finely adjust on the SUB CONTROL screen (!∞).

!∞SUB CONTROL screen

Finely adjust the selected item on the SUB CONTROL menu (!¢). Each control (CONTRAST, BRIGHT, CHROMA and PHASE control) has a click position at the center of its adjustment range. You can adjust the setting of the click position with this feature.

!§USER PRESET menu

If you select ON on this menu, the REMOTE indicator lights up and the controls on the front panel do not work. The monitor operates with the user preset settings.

To adjust the user preset settings, select the PRESET

ADJUST menu (!¶).

[OFF]

!¶PRESET ADJUST menu

You can preset the BRIGHT, CHROMA, PHASE, CONTRAST, VOLUME, and APERTURE controls to a desired level and can use these settings by selecting ON on the USER PRESET menu (!§).

!•PRESET ADJUST screen

Adjust the selected item (BRIGHT, CHROMA, PHASE, CONTRAST, VOLUME, and APERTURE control) on the PRESET ADJUST menu (!¶).

!ªV HOLD screen

Adjust the vertical hold if the picture rolls vertically. When you cannot read the display, select the input that is not connected.

@ºCOMPONENT LEVEL menu

Select the component level from among three modes.

N10/SMPTE

for 100/0/100/0 signal

BETA 7.5

for 100/7.5/75/7.5 signal

BETA 0

for 100/0/75/0 signal

For PVM-14M4U/14M2U/20M4U/20M2U

 

[BETA 7.5]

For PVM-14M4E/14M4A/14M2E/14M2A/20M4E/

20M4A/20M2E

[N10/SMPTE]

13