Note

The PHASE (6), CHROMA (7) and APERTURE (9) controls have no effect on the pictures of RGB signals.

0MENU (EXIT) button

Press this button to display the main menu.

When a menu is on the display, you can return to the previous menu by pressing this button.

!¡ ENTER (SELECT) button

Press the button to confirm a selected item on the menu.

!™ > (+)/ . (–) buttons

Press the buttons to move the cursor (z) or adjust selected item on the menu.

!£ 16:9 selector

Press this selector (light on) to monitor the signals of 16:9 picture.

!¢ H/V DELAY selector

Press this selector (light on) to observe the horizontal and vertical sync signals at the same time.

The horizontal sync signal is displayed in the left quarter of the screen; the vertical sync signal is displayed near the center of the screen.

!∞ UNDER SCAN selector

Press this selector (light on) for underscanning. The display size is reduced by approximately 5% so that four corners of the raster are visible.

!§ BLUE ONLY selector

RESET button

•As the BLUE ONLY selector, press this selector (light on) to eliminate the red and green signals. Only blue signal is displayed as an apparent monochrome picture on the screen. This facilitates “chroma” and “phase” adjustments and observation of VCR noise.

(“Phase” adjustment is effective only for the NTSC signals.)

•As the RESET button, you can reset the menu settings by pressing this button when a menu is on the display.

!¶ DEGAUSS button

Press this button momentarily. The screen will be demagnetized. Wait for 10 minutes or more before using this button again.

!• EXT SYNC (external sync) selector

•Set this selector to the off position (light off) to operate the monitor on the sync signal from the displayed video signal.

•Set this selector to the on position (light on) to operate the monitor on an external sync signal through the EXT SYNC connector.

!ª LINE/RGB input selector

Press this selector to select the input to be monitored.

•Set this selector to the off position (light off) to monitor the signal through the LINE A, LINE B or LINE C connectors.

•Set this selector to the on position (light on) to monitor the signal through the RGB/COMPONENT connectors.

@º C/SDI selector

•When the LINE/RGB input selector is set to the LINE position (light off), press this selector (light on) to monitor the signal through the LINE C connectors.

•When the LINE/RGB input selector is set to the RGB position (light on), press this selector (light on) to monitor the SDI signal (optional kits are required).

@¡ B/COMPONENT selector

•When the LINE/RGB input selector is set to the LINE position (light off), press this selector (light on) to monitor the signal through the LINE B connectors.

•When the LINE/RGB input selector is set to the RGB position (light on), press this selector (light on) to monitor the component signal through the RGB/ COMPONENT connectors.

@™ A/RGB selector

•When the LINE/RGB input selector is set to the LINE position (light off), press this selector (light on) to monitor the signal through the LINE A connectors.

•When the LINE/RGB input selector is set to the RGB position (light on), press this selector (light on) to monitor the RGB signal through the RGB/ COMPONENT connectors.

7