For Machines Mfg. Since 8/09 | M A I N T E N A N C E | Model SB1023 |
Service
Machine Storage
Never attempt to move this machine without first locking the table in place. If the machine is slightly tilted, the table could uncontrollably slide and fall off of the machine and cause machine damage or severe injury.
Machinery can develop serious rust problems and corrosion damage if it is not properly prepared for storage. If decommissioning this machine, use the steps in this section to ensure that it remains in good condition.
Short-term storage (less than year)
1.DISCONNECT MACHINE FROM POWER!
2.Thoroughly clean all unpainted, bare metal surfaces, then coat them with a rust preventative oil or wax specifically designed to protect machinery while in storage. DO NOT USE MOTOR OIL in storage situations as it does not sufficiently protect against rust.
3.Lubricate the machine as outlined in the Lubrication section on Page 30.
4.Cover and place the machine in an area that is out of direct sunlight and away from where paints and thinners are stored, or where gasses are present. Fumes and sunlight can bleach or discolor paint and clear plastic guards.
5.Once or twice a month, depending on humidity, wipe down the machine as outlined in Step 2.
6.Every two months, move all handwheels so the headstock and column move at least once in their full range of motion. This will keep the bearings, bushings, gears, and shafts well lubricated and protected from corrosion, especially during the winter months.
Longng-term-termstoragestorage (more than a year)
1.Empty and flush any cutting fluid pumps, lines, or tanks.
2.DISCONNECT MACHINE FROM POWER!
3.Thoroughly clean all unpainted, bare metal surfaces, then coat them with a heavy grease or rust preventative. Take care to ensure these surfaces are completely covered but that the grease or rust preventative is kept off painted surfaces. Make sure that both the upper and lower portions of the column leadscrew are completely coated with white lithium grease.
4.Remove the table, and then clean and pack the bearings with white lithium grease.
5.Using mineral spirits, clean and brush the ways, rack, pinion gear, and the leadscrew with any quality grease or wax that is specifically formulated for protecting machine parts during storage.
6.Open the main electrical box on the machine and place a few moisture absorbing desiccant packs at the bottom of the electrical box.
7.Cover and place the machine in an area that is out of direct sunlight and away from where paints and thinners are stored, or where gasses are present. Fumes and sunlight can bleach or discolor paint and clear plastic guards.
Note: When the machine is being put back into service from
