Dovetail Lock Cap
Screw
Taper Angle Control Knob
Figure 27. Taper angle control knob.
Turn the taper angle control knob until you reach "0" as indicated by the taper scale.
Using a 6mm hex wrench, tighten both dovetail lock cap screws.
Using a 6mm hex wrench, loosen both dovetail lock cap screws (one end shown in Figure 27).
Model SB1269
For Product Mfg. Since 1/10 |
| M A I N T E N A N C E |
|
To disable the taper attachment: | 3. |
| |
1. DISCONNECT LATHE FROM POWER!
2. Use an 8mm hex wrench, and loosen both deadman clamp cap screws shown in Figure 26, so the deadman can slide on the way as the carriage is moved.
Cap Screw
4.
5.
