Hardware Installation

SY-7VCA2

2-3.4 CMOS Clearing (JP5)

After you have turned off your computer, clear the CMOS memory by momentarily shorting pins 2-3 on jumper JP5, for a few seconds. Then restore JP5 to the initial 1-2 jumper setting in order to recover and retain the default settings.

Jumper JP5 can be easily identified by its white colored cap.

CMOS

Clear CMOS Data Retain CMOS Data

Clearing

JP5 Setting

Short pin 2-3 for

at least 5 seconds to clear the CMOS

1 2 3

Short pin 1-2 to retain new settings

1 2 3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

2-3.5 Power On

You have now completed the hardware installation of your Motherboard

successfully.

1.Turn the power on

2.To enter the BIOS Setup Utility, press the <DEL> key while the system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot up

sequence is completed. Then push the RESET button and press

<DEL> key again at the beginning of boot-up, during diagnostic

checks.

43

Page 47
Image 47
SOYO SY-7VCA2 user manual Cmos Clearing JP5, Power On, Clearing JP5 Setting