Speco Technologies KBD-927 instruction manual Install with ADR series

FASTRAX-2L Vxxx Slave ID = 1

Input Password : xxxx CAM:000

←Current Device ID = 1

←Default setting is 9999 for administrator 1111 for user

3.Press Ctrl + Menu. Set the Slave ID to 01

4.Set Slave Node to “B” in case that master keyboard model is KBD-927(N : NTSC,P : PAL)

Slave ID = 1 Slave Node : A/B

←A : KBD-927

RS485 Protocol

Half duplex mode Tx-,Tx+

			NO4	Tx- GND		Tx+				NO2
2.5 Install with ADR series			NC4							NC2
			COM4							COM2
			NO3							NO2
			NC3							NC2
			COM3							COM1
			GND							GND
22 AWG UTP CABLE			AL8							AL4
			AL7							AL3
			GND							GND
			AL6							AL2
			AL5	GND	Rx-(Tx-)	(Rx-) Rx+(Tx+)	AC- FGND (Rx+)	AC- AC+	AC+	AL1
		WIRE CONNECTION
		DOME	JUNCTION BOX
		R(T)X+	DOME1 +
		R(T)X-	DOME1 -
		ADR	JUNCTION BOX
		TX+	DOME2 +
		TX-	DOME2 -
J-BOX(FRONT)	J-BOX(REAR)	Remote Control
									RX+ RX- TX+ TX-
										RS-485
			RS-232 CABLE
		Remote Control
		ADR SERIES
	DATA2 DATA1

PTZ Control from DVR

Figure 9 – ADR Connection Diagram

If user wants to connect with ADR, proceed as the following order.

1)Connect RS232 cable between RS-232 Port of ADR and DVR port of the J-box. ( This connection enables ADR control remotely from KBD controller)

2)Connect wires between the TX(+/-) of ADR and Data2(+/-) of J-Box.

(This connection enables ADR PTZ control from the keyboard controller) 3) How to setup the controller.

16