Speco Technologies KBD-927 instruction manual Install with IDR series, IDR Connection Diagram

2.7 Install with IDR series

22 AWG UTP CABLE

J-BOX(FRONT)	J-BOX(REAR)
	DATA2	DATA1

WIRE CONNECTION

DOME JUNCTION BOX

R(T)X+ DOME1 +

R(T)X- DOME1 -

CONVERTER	JUNCTION BOX
TX+(RS-485)	DOME2 +
TX-(RS-485)	DOME2 -

RS-232 CABLE

IDR SERIES

RS-232C to RS-485

CONVERTER

Figure 11 – IDR Connection Diagram

If user wants to connect with IDR, please proceed as the following order.

1)Connect RS-232C cable between RS-232C Port of IDR and DVR port of the J-box. ( This connection enables IDR control remotely from KBD controller)

2)Plug the RS-232C TO RS-485 converter in the RS-232C Port of IDR. Connect wires between the TX(+/-) of converter and Data2(+/-) of J-Box.

(This connection enables IDR PTZ control from KBD controller)

3)How to setup the controller.

A.SWITCH THE KBD controller ON

B.INPUT PASSWORD (Factory Setting is 9999)

C.Open the menu of the KBD controller by pressing Ctrl + Menu Key.

D.Set as below in Network menu.

Set Baud Rate

	Dome	:	9600
	Mux	:	9600
	DVR485 :		9600
	DVR232 :		9600
	Com Ports
	Dome	:	Dome
	Mux	:	None
	DVR485 : AUX IN
	DVR232 : IDR
4) How to setup IDR

22