SpectraLink 72-1084-02 manual Crc

SpectraLink Corporation		Setup and Administration—NetLink e340/i640 Wireless Telephone
		Mitel Networks ICP and 5220 IP Phone emulation
Message		Description	Action
Press End Call	Your call has ended.		Press the Power Off / End Call key
			to return to standby mode.
Restart Command	The Wireless Telephone received a		None. The Wireless Telephone
	restart command from the supported		will automatically restart in a few
	Mitel Networks VoIP solution.		seconds.
Select License	The correct protocol has not been		Using the administrative menus,
	selected from the license set.		select one license from the set to
			allow the phone to download the
			appropriate software.
Server Busy	Wireless Telephone is attempting to		None, the Wireless Telephone will
	download from a TFTP Server that is		automatically retry the download
	busy downloading other devices and		every few seconds.
	refusing additional downloads.
SVP Service Rej.	The NetLink SVP Server has		The Wireless Telephone will restart
	rejected a request from the Wireless		and attempt to re-register with the
	Telephone.		SVP Server, which should fix the
			problem. Report to your
			administrator if it keeps happening.
System Locked	NetLink SVP Server is locked.		Try call again later, system has
(with Busy Tone)			been locked for maintenance.
System Busy	NetLink SVP Server is busy or out of		All call paths are in use, try call
(with Busy Tone)	resources.		again in a few minutes.
TFTP ERROR(x):yy	A failure has occurred during a TFTP		Error code 01, 02 or 07 - check the
	software download. (x) = The file		TFTP server configuration.
	number which was being		Error code 81, the Wireless
	downloaded; yy is an error code
			Telephone will attempt to
	describing the particular failure.
			download the file again.
	Possible error codes are:
			For other messages, power off the
		01 = TFTP server did not find the
		requested file.	Wireless Telephone, then turn it on
		02 = Access violation (reported	again to retry the download. If the
			error repeats, note it and contact
		from TFTP server).
			SpectraLink Technical Support.
		07 = TFTP server reported "No
		such user" error.
		81 = File put into memory did not
		CRC.
		FF = Timeout error. TFTP server
		did not respond within a specified
		period of time.
Updating Code…	Wireless Telephone is downloading		None. When the progress bar fills
	new software into memory.		the display line the update
			operation is complete on that file.
Updating …	The Wireless Telephone is internally		None. The Wireless Telephone
	updating its software images.		may do this briefly after a
			download. This is informational
			only.

PN: 72-1084-02-B.doc Page 40