SpectraLink SVP010, SVP020, SVP100 manual Installing the NetLink SVP Server, Required Materials

SpectraLink Corporation	Installation, Configuration, and Administration
	NetLink SVP Server (within IP environments)

3.Installing the NetLink SVP Server

As shown in the system diagram, the NetLink SVP Server is connected to the Ethernet switch. The specifications covered here allow for great flexibility in physical placement of the components within stated guidelines.

See the Configuration and Administration document for your vendor’s IP system for information on LAN requirements, network infrastructure and IP addressing.

3.1Required Materials

The following equipment must be provided by the customer.

•Power Outlet – AC adapter provided by SpectraLink..

•Backboard space – the NetLink SVP Server is designed to be wall- mounted to ¾" plywood securely screwed to the wall.

•Screws – required to mount the NetLink SVP Server to the wall. Four #8 ¾" panhead wood screws (or similar device) are required.

•Cat. 5 Cable – RJ-45 connector at the NetLink SVP Server. Connection to Ethernet switch.

3.2Locate the NetLink SVP Server

The NetLink SVP Server measures approximately 4 x 12.5 x 7 inches, and weighs about five pounds. The unit can be wall- mounted, vertically or horizontally, over ¾" plywood. The SVP Server can also be rack- mounted using a rack- mount kit (sold separately).

Locate the NetLink SVP Server in a space with:

•Sufficient backboard mounting space (for wall mount) and proximity to the LAN access device (switched Ethernet hub) and power source.

•Easy access to the front panel, which is used for cabling.

•A maximum distance of 325 feet (100 meters) from the Ethernet switch.

3.3Install the NetLink SVP Server

The NetLink SVP Server may be mounted on a rack or to a wall.

Mount the SVP Server on a rack

The rack-mount kit is designed for mounting equipment in a standard 19- inch rack and should contain the following equipment:

•Mounting plates – two for each SVP Server to be mounted.

•Screws – four rack-mount screws for each SVP Server to be mounted.

To rack-mount the NetLink SVP Server:

Remove the corner screws from the SVP Server.

Screw the U-shaped end (round screw holes) of the two mounting plates to the SVP Server.

PN: 72-0178-01-F.doc Page 14