Manuals / SpectraLink / Computer Equipment / Network Card

SpectraLink SVP010, SVP020, SVP100 manual Index

Models: SVP100 SVP010 SVP020

1 35

Download 35 pages 63.67 Kb

Page 35

SpectraLink Corporation	Installation, Configuration, and Administration
	NetLink SVP Server (within IP environments)

Access point, description, 10

Alarms, 27

Configuration

Initial setup, 17

Customer Support Hotline, 5

Download master, 18

Downloading Software Updates, 25

Error Status, 27

Ethernet switch, description, 10

Hotline, 5

NetLink SVP Server

Front Panel, 12

NetLink SVP Server, 6, 11

NetLink SVP Server

Location, 13

Index

NetLink SVP Server

Mounting, 13

NetLink SVP Server

Mounting, 14

NetLink SVP Server Alarms, 27 NetLink SVP Server, administration, 15 Network Status, 28

Power, 13

Serial Connection, 15

Site Preparation, 13

Software Updates, 25

Telnet, 15

TFTP Download Master, 18

Wireless Telephone, description, 10

PN: 72-0178-01-F.doc

Page 35

Image 35

SpectraLink SVP010, SVP020, SVP100 manual Index

Contents

For Cisco and Mitel IP environments Installation, Configuration, and AdministrationNetLink SVP Server SVP100 SVP020 SVP010Trademark Information IMPORTANT SAFETY INFORMATION Software Maintenance Table of Contents3. Installing the NetLink SVP Server Configuring the NetLink SVP Server1. About This Document NetLink Wireless Telephone Configuration and AdministrationNetLink Wireless Telephone WLAN Compatibility List Deploying Enterprise-Grade Wi-Fi Telephony white paper2.3 The Timing Function 2.1 SpectraLink Voice Priority SVP and Quality of Service2. NetLink SVP Server Overview 2.2 SVP Server ModelsNetLink SVP100 Server Capacity 2.5 Multiple SVP Servers/Master SVP Server2.6 Multiple NetLink SVP Server Capacities NetLink SVP010 and SVP020 Server CapacityPage 2.7 Notes on System Configuration access point 2.8 System DiagramIP telephony system example access point2.9 System Components Access pointsEthernet switch Administrative computerInstallation, Configuration, and Administration TFTP ServerLink LEDs 2.10 The Front Panel of the NetLink SVP Server3.2 Locate the NetLink SVP Server 3. Installing the NetLink SVP Server3.3 Install the NetLink SVP Server 3.1 Required MaterialsConnect NetLink SVP Server to LAN Connect PowerMount the NetLink SVP Server to a wall Connect via the Serial Port 4. Configuring the NetLink SVP Server4.1 Connecting to the NetLink SVP Server Connecting Via Telnet4.2 The NetLink SVP-II System Menu SendAll 4.3 Network ConfigurationThe following options must be configured As set in WINS SVP-II Mode 4.4 SVP Server ConfigurationFirst Alias IP Address/Last Alias IP Address Phones per Access Point802.11 Rate SVP-II Master Alias IP Addresses are not necessary in Cisco systems QoS Configuration Note Default DSCP settings will mark traffic for Best Effort handling under normal circumstances. Please consider changing these values based on the recommended QoS settings from your network hardware manufacturer to achieve prioritization for your voice traffic 4.5 Change Password Changing the Master SVP Server 5. Swapping/Adding/Deleting SVP ServersAdding an SVP Server Removing an SVP ServerSoftware Updates 6. Software Maintenance7. Troubleshooting via System Status Menu 7.1 Error Status 7.2 Network Status packets - packets received 7.3 Software Version Alias/Phone Number-phone identifier 7.4 Gatekeeper DatabaseIndex