Manuals / SpectraLink / Computer Equipment / Network Card

SpectraLink SVP010, SVP020, SVP100 manual The NetLink SVP-II System Menu

Models: SVP100 SVP010 SVP020

1 35

Download 35 pages 63.67 Kb

Page 17

4.2The NetLink SVP-II System Menu

SpectraLink Corporation	Installation, Configuration, and Administration
	NetLink SVP Server (within IP environments)

4.2The NetLink SVP-II System Menu

The main menu displays as shown here:

System Status

Menu for viewing error messages, status of operation and software code version.

SVP-II2Configuration

Allows you to set the mode and reset the system.

Network Configuration

Allows you to set network configuration options, including IP address and hostname.

Change Password

Allows you to change the password for NetLink SVP Server access.

2SVP-II is a designation used internally by SpectraLink Engineering.

PN: 72-0178-01-F.doc

Page 17

Image 17

SpectraLink SVP010, SVP020, SVP100 manual The NetLink SVP-II System Menu

Contents

NetLink SVP Server Installation, Configuration, and AdministrationSVP100 SVP020 SVP010 For Cisco and Mitel IP environmentsTrademark Information IMPORTANT SAFETY INFORMATION 3. Installing the NetLink SVP Server Table of ContentsConfiguring the NetLink SVP Server Software MaintenanceNetLink Wireless Telephone WLAN Compatibility List NetLink Wireless Telephone Configuration and AdministrationDeploying Enterprise-Grade Wi-Fi Telephony white paper 1. About This Document2. NetLink SVP Server Overview 2.1 SpectraLink Voice Priority SVP and Quality of Service2.2 SVP Server Models 2.3 The Timing Function2.6 Multiple NetLink SVP Server Capacities 2.5 Multiple SVP Servers/Master SVP ServerNetLink SVP010 and SVP020 Server Capacity NetLink SVP100 Server CapacityPage 2.7 Notes on System Configuration IP telephony system example 2.8 System Diagramaccess point access pointEthernet switch Access pointsAdministrative computer 2.9 System ComponentsInstallation, Configuration, and Administration TFTP ServerLink LEDs 2.10 The Front Panel of the NetLink SVP Server3.3 Install the NetLink SVP Server 3. Installing the NetLink SVP Server3.1 Required Materials 3.2 Locate the NetLink SVP ServerConnect NetLink SVP Server to LAN Connect PowerMount the NetLink SVP Server to a wall 4.1 Connecting to the NetLink SVP Server 4. Configuring the NetLink SVP ServerConnecting Via Telnet Connect via the Serial Port4.2 The NetLink SVP-II System Menu SendAll 4.3 Network ConfigurationThe following options must be configured As set in WINS SVP-II Mode 4.4 SVP Server Configuration802.11 Rate Phones per Access PointSVP-II Master First Alias IP Address/Last Alias IP Address Alias IP Addresses are not necessary in Cisco systems QoS Configuration Note Default DSCP settings will mark traffic for Best Effort handling under normal circumstances. Please consider changing these values based on the recommended QoS settings from your network hardware manufacturer to achieve prioritization for your voice traffic 4.5 Change Password Adding an SVP Server 5. Swapping/Adding/Deleting SVP ServersRemoving an SVP Server Changing the Master SVP ServerSoftware Updates 6. Software Maintenance7. Troubleshooting via System Status Menu 7.1 Error Status 7.2 Network Status packets - packets received 7.3 Software Version Alias/Phone Number-phone identifier 7.4 Gatekeeper DatabaseIndex