Manuals / SpectraLink / Computer Equipment / Network Card

SpectraLink SVP020, SVP100, SVP010 manual SVP Server Configuration, SVP-II Mode

Models: SVP100 SVP010 SVP020

1 35

Download 35 pages 63.67 Kb

Page 21

4.4SVP Server Configuration

SpectraLink Corporation	Installation, Configuration, and Administration
	NetLink SVP Server (within IP environments)

4.4SVP Server Configuration

The SVP-II Configuration screen is where you set the mode of the NetLink SVP Server. It is also where you can lock the NetLink SVP Server for maintenance and reset the NetLink SVP Server after maintenance. The type of gateway you are using determines the mode of the NetLink SVP Server.

From the main menu, scroll to SVP-II Configuration and select by pressing Enter.

SVP-II Mode

Defaults to NetLink IP for an IP environment. Press enter to select and the screen is immediately redrawn with additional options for the IP environment.

PN: 72-0178-01-F.doc

Page 21

Image 21

SpectraLink SVP020, SVP100, SVP010 manual SVP Server Configuration, SVP-II Mode

Contents

NetLink SVP Server Installation, Configuration, and AdministrationSVP100 SVP020 SVP010 For Cisco and Mitel IP environmentsTrademark Information IMPORTANT SAFETY INFORMATION 3. Installing the NetLink SVP Server Table of ContentsConfiguring the NetLink SVP Server Software MaintenanceNetLink Wireless Telephone WLAN Compatibility List NetLink Wireless Telephone Configuration and AdministrationDeploying Enterprise-Grade Wi-Fi Telephony white paper 1. About This Document2. NetLink SVP Server Overview 2.1 SpectraLink Voice Priority SVP and Quality of Service2.2 SVP Server Models 2.3 The Timing Function2.6 Multiple NetLink SVP Server Capacities 2.5 Multiple SVP Servers/Master SVP ServerNetLink SVP010 and SVP020 Server Capacity NetLink SVP100 Server CapacityPage 2.7 Notes on System Configuration IP telephony system example 2.8 System Diagramaccess point access pointEthernet switch Access pointsAdministrative computer 2.9 System ComponentsInstallation, Configuration, and Administration TFTP ServerLink LEDs 2.10 The Front Panel of the NetLink SVP Server3.3 Install the NetLink SVP Server 3. Installing the NetLink SVP Server3.1 Required Materials 3.2 Locate the NetLink SVP ServerConnect Power Mount the NetLink SVP Server to a wallConnect NetLink SVP Server to LAN 4.1 Connecting to the NetLink SVP Server 4. Configuring the NetLink SVP ServerConnecting Via Telnet Connect via the Serial Port4.2 The NetLink SVP-II System Menu SendAll 4.3 Network ConfigurationThe following options must be configured As set in WINS SVP-II Mode 4.4 SVP Server Configuration802.11 Rate Phones per Access PointSVP-II Master First Alias IP Address/Last Alias IP Address Alias IP Addresses are not necessary in Cisco systems QoS Configuration Note Default DSCP settings will mark traffic for Best Effort handling under normal circumstances. Please consider changing these values based on the recommended QoS settings from your network hardware manufacturer to achieve prioritization for your voice traffic 4.5 Change Password Adding an SVP Server 5. Swapping/Adding/Deleting SVP ServersRemoving an SVP Server Changing the Master SVP ServerSoftware Updates 6. Software Maintenance7. Troubleshooting via System Status Menu 7.1 Error Status 7.2 Network Status packets - packets received 7.3 Software Version Alias/Phone Number-phone identifier 7.4 Gatekeeper DatabaseIndex