SpectraLink Corporation | Installation, Configuration, and Administration |
| NetLink SVP Server (within IP environments) |
The following options must be configured:
Phones per Access Point
AP specifications are detailed in the Configuration Notes for each brand and type. Refer to these notes when entering the number of simultaneous calls supported for your type.
802.11 Rate
Select 1MB/2MB to limit the transmission rate between the wireless telephones and APs. Select Automatic to allow the wireless telephone to determine its rate (up to 11 Mb/s).
The master SVP Server must be identified in an IP system. Select one of the following identification options:
•Statically configure the IP address of the master SVP Server in each of the SVP Servers. Enter the IP address.
See the Overview section for an explanation of the master SVP Server.
•Statically configure the IP address of the master SVP Server in a DHCP server and configure each of the SVP Servers to get the information from the DHCP server. Enter DHCP. If DHCP is used, the IP address of the master SVP Server must be configured in the DHCP server. See the wireless telephone interface document for your IP environment for more information about DHCP integration factors.
•Statically configure the IP address of the master SVP Server in a DNS server and configure the each of the SVP Servers to retrieve this information from the DNS server. Enter DNS. If DNS is used, the IP address of the master SVP Server must be configured in the DNS server.
First Alias IP Address/Last Alias IP Address
The SVP Server uses an IP address when acting as a proxy for the wireless telephone. Therefore, one alias IP address is required for every installed NetLink Wireless Telephone. These IP addresses must be entered as a range and must be assigned solely for this purpose.
When multiple SVP100 Servers are installed, a different range must be configured in each SVP Server. In determining how many addresses to configure per SVP Server, use this formula: (# of handsets / # of SVP Servers) + 30%. This formula will accommodate the possibility of unequal distribution of handsets among the available SVP Servers.
All alias addresses must be on the same subnet as the SVP Server and cannot be duplicated on other subnets or SVP Servers. There is no limit to the number of addresses that can be assigned, but the capacity of each SVP Server is 500 wireless telephones.
PN: | Page 22 |
