Turn on the water supply faucets and flush the lines for approximately two minutes to remove any foreign materials that could clog the screens in the water mixing valve.
NOTE: When installing in newly constructed or renovated building, it is very important to flush the lines since
Connecting Hoses
Insert each filter screen into the end of each fill hose that will connect to the water supply faucet. The screen must be facing outward. Refer to Figure 3.
Insert each plain rubber washer into the other end of each fill hose that will connect to the water mixing valve at the rear of the washer. Refer to Figure 3.
Thread hose couplings onto valve connections finger- tight, then approximately 1/4 turn with pliers.
IMPORTANT: DO NOT cross thread or overtighten couplings.
Turn water on and check for leaks. If leaks are found, retighten the hose couplings. Continue tightening and rechecking until no leaks are found.
1
COLD
HOT | 3 |
2
4 
TLW1976N
1Faucet
2Fill Hoses
3Plain Rubber Washer
4Filter Screens
Figure 3
Installation
IMPORTANT: Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to.
All hoses should be checked on a monthly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years.
2 3
1
| WATER |
4 | MIXING |
VALVE | |
| FLW1974N |
| FLW1974N |
1Water Supply Faucets
2Hot Water Connection
3Cold Water Connection
4Fill Hoses
Figure 4
IMPORTANT: Turn off water supply faucets after
NOTE: Longer fill hoses are available (as optional equipment at extra cost) if the hoses supplied with the washer are not long enough for the installation. Order hoses as follows:
No. 20617 Fill Hose (8 feet) (2.44 m)
No. 20618 Fill Hose (10 feet) (3.05 m)
802733 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 9 |