Maintenance

Reinstallation of Shipping Materials

To prevent damage while moving the washer, the shipping materials MUST be reinstalled.

●Disconnect washer from electrical supply.

●While supporting the front access panel, remove two screws from the bottom edge of the panel.

●Gently lower the panel to remove it from the washer.

●Place the shock sleeves on all four shock absorbers. Refer to Figure 30.

●Insert hooked end of shipping brace into the open slot of the motor mount. Refer to Figure 30.

●Attach the brace with the five bolts and washers. Refer to Figure 30.

●Reinstall front access panel.

1

2 3

FLW2124N

4

FLW2124N

1Shock Sleeves

2Motor Mount

3Hooked End of Shipping Brace

4Bolts and Lockwashers

Figure 30

Refer to Installation section, step 6 for proper procedures whenever the washer is moved.

Cleaning Foreign Object Trap

The washer’s pump has a trap that may collect foreign objects. The trap may need to be cleaned if water is draining slower than usual. To clean:

●Disconnect washer from electrical supply.

●While supporting the front access panel, remove two screws from the bottom edge of the panel.

●Gently lower the panel to remove it from the washer.

NOTE: The pump may have some water in it. Use a rag or a container to catch water. If the wash drum is full of water, use a wet/dry shop vacuum to catch the water.

●With rag or vacuum ready, unscrew the cap on the left side of the pump and remove trap.

●Clean the debris from the trap.

●Reinstall the trap and access panel.

●Reconnect washer to electrical supply.

26

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

802733