Step 6: Remove the Shock Sleeves and Shipping Brace

Remove front access panel by removing the two screws at the bottom of the panel.

Remove the five bolts and lockwashers from shipping brace with 9/16 in. wrench and remove brace. Refer to Figure 10. Four bolts are located on the washer base and one is holding the brace to the weight. Remove all four shock sleeves by pulling on the yellow rope. Remove label from front side of front access panel and place on backside of front access panel for future reference.

NOTE: The shipping brace, bolts, washers and shock sleeves should be saved and MUST be reinstalled whenever the washer is moved more than four feet. Refer to User-Maintenancesection for instructions. Do not lift or transport washer from front or without shipping materials installed.

Store the shipping materials in the accessories bag. Save materials for use whenever the washer is moved.

Reinstall front access panel.

IMPORTANT: DO NOT tip washer more than

6 inches (152.4 mm) in any direction after shipping brace has been removed. Shock absorbers may separate and damage to washer may result. For leveling purposes, the washer may be tilted a maximum of 6 inches (152.4 mm) in any direction.

1

2

Installation

Step 7: Wipe Out Inside of Wash Drum

Before using washer for the first time, use an all-purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside wash drum.

FLW2115N

Figure 11

Step 8: (Supply Injection Models Only) Connect External Supplies to Washer

IMPORTANT: Undiluted chemical dripping can damage the washer.

1.Remove two nozzles from accessories bag. Use either the 3/8 inch or 1/4 inch nozzles, depending on the diameter of the dispenser tubing used.

2.Attach nozzles to rear of machine. Connection point located on cabinet, above water mixing valve. Refer to Figure 12.

3.Connect supply hoses to nozzles and secure with hose clamps (obtain locally). Refer to Figure 12.

NOTE: Hoses can be connected to either nozzle.

4. Refer to supply injection system instructions and

label inside washer junction box cover

4

3

FLW2124N

FLW2124N

(Figure 13) for electrical connection.

Do not attempt to make supply injection electrical

connections to points other than those provided

specifically for that purpose by the factory.

5. Refer to supply injection system instructions for

1Shock Sleeves

2Motor Mount

3Hooked End of Shipping Brace

4Bolts and Lockwashers

Figure 10

details on operation.

802733

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

13