Installation
Installing the Washer
Step 1: Position Washer Near Installation Area
Move washer so that it is within 4 feet (1.2 meters) of the desired area of installation.
NOTE: For best performance and to minimize vibration or movement, install washer on a solid, sturdy and level floor. Some floors may need to be reinforced, especially on a second floor or over a basement. Do not install the washer on carpeting, soft tile, a platform or other weakly supported structures.
H054I
H054I
Figure 2
Step 2: Connect Fill Hoses
WARNING
Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used for such a period and before using the washer, turn on all hot water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. THE GAS IS FLAMMABLE, DO NOT SMOKE OR USE AN OPEN FLAME DURING THIS TIME.
W029
Water Supply
Water supply faucets must fit standard 3/4 inch (19.1 mm) female garden hose couplings. DO NOT USE
Water supply faucets should be readily accessible to permit turning them off when washer is not being used.
Recommended cold water temperature is 60° to 80° Fahrenheit (16° to 27 Celsius). Recommended maximum hot water temperature is 125° Fahrenheit (51° Celsius). Warm water is a mixture of hot and cold water. Warm water temperature is dependent upon water temperature and pressure of both the hot and cold water supply lines.
WARNING
To avoid personal injury, recommended inlet water temperature should be no higher than 125° Fahrenheit (51° Celsius).
W709
Water pressure must be a minimum of 20 to a maximum of 120 pounds per square inch (138 to 827 kPa) static pressure measured at the faucet.
NOTE: Water pressure under 20 pounds per square inch (138 kPa) will cause an extended fill time in the washer and may not properly flush out the detergent dispenser.
8 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 802733 |