
Hoses With Metric Coupling
Connect the BLACK colored hose coupling end of the fill hoses (with filter screens) to the water supply faucets. Then connect end of hoses with the brass colored hose couplings to the hot and cold water mixing valve connections at rear of washer.
IMPORTANT: Thread hose couplings onto valve connections finger tight, then turn 1/4 turn with pliers. DO NOT cross thread or overtighten couplings.
14
| 3 |
COLD |
|
HOT |
|
2 | C |
| |
| H |
8
5
7
6
TLW1988N
1Filter Screen (Screen must be facing outward)
2Fill Hose
3Rubber Washer (Plain)
4Cold Water Connection
5Hot Water Connection
6Install this end of hose to valve connections at rear of washer.
7Install this end of hose to water supply faucet. (Black colored coupling for metric)
8Faucet
Figure 5
IMPORTANT: Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to.
All hoses should be checked on a yearly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years.
Installation
Step 4: Connect Drain Hose to Drain ReceptacleRefer to section on Drain Facilities before connecting drain hose to drain receptacle.
Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp.
Follow the instructions for your type of drain receptacle (high standpipe or low standpipe) to properly install the drain hose.
IMPORTANT: Drain receptacle must be capable of handling a minimum of 3,8 cm
1
RECOMMENDED
STANDPIPE
HEIGHT
92 cm MINIMUM
(36 inches)
2
W294I
1Drain Hose
2Standpipe
Figure 6
38970 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 13 |