
The following list is the procedure required to install the Phillips head screw and
1.Remove the Phillips head screw from service door (refer to Figure 19).
2.Remove two screws holding control panel to control hood (refer to Figure 19).
3.Tilt control panel forward and lay on a protective pad to prevent scratching of cabinet top.
4.Insert Phillips head screw down through double “D” hole in left rear corner of cabinet top (inside control hood) until it engages retainer nut located on left rear corner gusset of cabinet (refer to Figure 19).
5.Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten screw. Torque of a power driver could
WARNING
Any disassembly requiring the use of tools must be performed by a suitably qualified service person.
W299
NOTE:
6.Secure control panel to control hood using two No. 8
7.Remove two screws holding front panel to base of washer and install two No. 12
Installation
2
1
W276I
3
W276I
135528 No. 8 Screws
2Double “D” Hole
335527 No. 12 Screws
Figure 19
Bit (No. 8 screws) Part No. 281P4
Bit (No. 12 screws) Part No. 282P4
Bit Holder (3/8 drive) Part No. 24161
Control Panel
38970 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 23 |