SPX Cooling Technologies CS4000 manual Figures

CS4000 Mini Controller with Ethernet

Figures

Figure 1-1.	Example of an Ethernet Network with a Connected Portable Laptop				1-3
Figure 1-2.	Example of a 485 Network				1-5
Figure 3-1.	Front Panel View				3-2
Figure 3-2.	Top Panel View				3-3
Figure 3-3.	Bottom Panel View				3-4
Figure 3-4.	Components Inside the Enclosure of the CS4000 Mini Controller
	with Ethernet				3-7
Figure 3-5.	Front View of the TCM				3-8
Figure 3-6.	Rear View of the TCM and Location of the Servo Amplifier Fuse				3-9
Figure 3-7.	DCM Board and DCM Battery Location				3-10
Figure 3-8.	CS4000 Mini Controller with Ethernet Backplane				3-11
Figure 3-9.	I/O Board				3-13
Figure 3-10.	Ethernet Interface Card				3-14
Figure 3-11.	Interbus-S Module Side View				3-16
Figure 3-12.	Interbus-S Module Top View				3-17
Figure 3-13.	Ground Fault Circuit Interrupter				3-18
Figure 4-1.	CS4000 Mini Controller with Ethernet Dimensions				4-2
Figure 4-2.	Power/Connection Requirements				4-3
Figure 4-3.	Remote Input Circuit Schematics				4-8
Figure 4-4.	Example of CS4000 Controller Remote I/O Wiring −			Sourcing Outputs	4-9
Figure 4-5.	Example of CS4000 Controller Remote I/O Wiring −			Sinking Outputs	4-10
Figure 5-1.	Message Upon Starting the TINI Ethernet Interface Flash Utility				5-3
Figure 5-2.	Selecting the COM Port Menu				5-4
Figure 5-3.	Selecting ‘COM1’ RS-232 Port				5-4
Figure 5-4.	Establishing A Successful Connection via COM1				5-5
Figure 5-5.	Error Message Displayed when COM1 is Already In Use				5-5
Figure 5-6.	Selecting the “Flash TINI…” Option				5-6
Figure 5-7.	Selecting the	..........................................................................Application File			5-6
Figure 5-8.	Error Message Displayed when the Attempted Connection Fails				5-7
Figure 5-9.	Error Message Following An Unsuccessful Flash Attempt				5-7
Figure 5-10.	Second Error Message Following An Unsuccessful Flash Attempt				5-7
Figure 5-11.	Confirming the IP Address, Subnet Mask and Default Gateway				5-8
Figure 5-12.	Selecting the “Set TINI Application Info…” Menu Option				5-10
Figure 5-13.	Viewing the Application Settings Window - General Info tab				5-11
Figure 5-14.	Selecting the Application Settings Window -		Ip Address tab		5-11
Figure 5-15.	Selecting the Application Settings Window -		Comm Options tab		5-12
Figure 5-16.	VSMain.ini configured for an Ethernet Network				5-14
Figure 5-17.	Select the Icon and Enter A Name for the Hyperterminal Connection				5-18
Figure 5-18.	Select Communications Port				5-19
Figure 5-19.	Setting the Communications Port Settings				5-20
Figure 5-20.	Hyperterminal Window Showing Ethernet Interface Card (TINI)
	Login Prompt				5-21
Figure 5-21.	Opening the Command Prompt Window				5-23

Page x T-38324-A 39-30-38324