ASSEMBLY INSTRUCTIONS
STEP 10
Attach the HANDRAIL(20) to the FRONT SUPPORT(6) with BUTTON HEAD BOLTS(M8x1.25x15mm)
(55) and WASHERS(M8)(69).
STEP 11
NOTE: Do not over tighten BOLTS(56, 59) as PULLEYS(23) must rotate freely after BOLTS(56, 59) are
tightened.
Run the Eyelet End of the LAT BAR CABLE(25), 2050mm (80.7”) long, through the slot at the top end
of the TOP BEAM(5). Attach the BALL END of the LAT BAR CABLE(25) to the TOP BEAM(5)with a
PULLEY(23), a BUTTON HEAD BOLT(M8x1.25x115mm )(59), a NYLOCK NUT(M8x1.25)(67), two
WASHERS(M8)(69), and two PULLEY SPACERS(24). Attach the LAT BAR CABLE(25) to the bracket
on the TOP BEAM(5) with a PULLEY(23), a BUTTON HEAD BOLT BOLT(M8x1.25x45mm)(56), a
NYLOCK NUT(M8x1.25)(67), two WASHERS(M8)(69), and the WIDE CABLE GUIDE(26).
10
Eyelet End