Stanton C.504 manual Fader Start, Relay Play

button. If there is a track memory data for the current selected track, its memory number is shown in the LCD.

3.When track memory number is shown in the LCD, pressing the ENTER button recalls the track memory data.

The C.504 can recall the track (selection #) from the track memory data.

1.Select the memory bank [BANK] by pressing and holding the SHIFT button then pressing the PITCH RANGE button. If there is a track memory data of selected track in the current selected memory bank (A to E), the “M” indicator in the LCD lights.

2.Enter the recall mode [RECALL DISPLAY] by pressing and holding the SHIFT button then press- ing the TIME/ENTER button. If there is a track memory data for the current selected track, its mem- ory number is shown in the LCD. Use the Jog wheel to select the desired track memory number.

3.When the appropriate track memory number is shown in the LCD, pressing the ENTER button recalls the track from the track memory number.

NOTE:

CUE 1-3 and loop points can be memorized and/or recalled. However, just after the recall opera- tion, start from the CUE 1-3 or loop points will not be seamless when performed on the first try (because there are no data in the RAM buffer just after the recall operation). Once playing from cue points (CUE 1-3) and/or loop start point, flash start and/or looping can again be performed seam- lessly.

3-8. Fader Start

Connect the Fader Start jack on the rear panel of the main unit and Fader Start jack on the external device which supports the fader start function (for example RM-series mixers, SMX-401, SMX-211). Use the Fader Start cable which is supplied to perform the fader start/back cue performance via mixer’s crossfader. Check your mixer’s owner’s manual for verification of this feature

TIP:	Start (low active, more than 50ms)
GND:	Back cue (low active, more than 50ms)

NOTE:

When using this feature along with MP3 discs, the GND is not active and back cue is not operational.

3-9. Relay Play

Pressing and holding the SHIFT button then pressing the PLAY/PAUSE button [RELAY PLAY] turns the relay play function on and off. When the relay play is turned on, the “RELAY” indicator is dis- played in the LCD screen.

NOTE:

Turning on the Relay play function either control unit 1 or 2 turns on the relay play function. While the relay play is activated, when unit 1 finishes playback, unit 2 will start playback automatically, and vice versa.