Reverse micro feed
To feed the paper through the printer in reverse in small steps, first put the printer in
Setting the auto load position
Each time the printer feeds in a sheet of paper, it always starts printing at the same distance from the top of the page. This is referred to as the auto load position. If you want to change this setting, you can do so as follows.
. Load one or more sheets of paper into the tray.
. Press the [PAPER]key twice to feed in the top sheet of paper ready for printing.
Note: | You can only alter | this setting | immediately after loading | |
| paper. If you feed | the | top sheet | further through the printer by |
| pressing the (PAPER] | key more | than once, a new auto load | |
| setting cannot be saved. |
|
.
.
.
Put the printer in |
| |
Hold down the [READY)key and adjust the position of |
| |
the paper by pressing either the [PAPER] key (to |
| |
advance the paper) or the [FONT]key (to wind the | - | |
paper back in small steps). | ||
| ||
When you have positioned the paper as you want it, |
| |
press the [READY]key to save the setting. |
|
This setting will remain in effect until you change it again or until you turn off the printer.
Note: You can also save the current auto load setting so that it is retained even when the printer is switched off and on again. See Saving current settings on page 62.
Page 60