*** DOT ADJUSTMENT SETTING ***
LQ |
|
| |
| +[FONT] | [PAPERJ~ |
|
Each time you press either of these two keys, the printer |
| ||
prints a new test line and a new offset value. |
| ||
If you are using fanfold paper, the printer will reverse |
| ||
feed the paper before printing the test pattern again. |
| ||
After printing the pattern, the printer will feed the fan- |
| ||
fold paper back up again | so that you can see it clearly. | - | |
In the illustration above, you would want to move the bottom row to the right: pressing the [PAPER] key would give you the following
*** DOT ADJUSTMENT SETTING ***
.
.
The bars are better aligned now. Keep using the [PAPER] key until the two rows are aligned.
You have now aligned the printer in Letter Quality (LQ) mode. By pressing the (READY]key, you can now correct the dot alignment of draft mode.
There are five modes in which the dot alignment may need to be corrected: LQ, DJ3@R DFUWT COND (con- densed), GRAPHICS A and GI&F’HICS B. Each mode must be adjusted separately. Cycle through these modes by pressing the [READY)key (“cycling” means that if you are in the last mode, GRAPHICS B, and you press the [READY)key, the printer will go back to LQ mode). The dif- ferent modes may have different alignments because of the way in which the printer’s electronics drive the mov- ing parts.
. When you have adjusted all the dot alignments, hold down the (READY]key and press the [PAPER] key. The printer will print “*** END ***“, eject the current page and go into ready mode.
Page 66
