Star Micronics RS232 manual Commands to Move the Print Position

Commands to Move the Print Position

FUNCTION		Line feed
		<LF>
CODE
		0A
HEX
		Prints the current line and feeds the paper to the next line.
REMARKS
		Carriage return
FUNCTION
		<CR>
CODE
		0D
HEX
		Prints the current line and feeds the paper to the next line.
REMARKS
		This command is ignored when CR code is invalid.
		Feed paper n lines
FUNCTION
		<ESC>	“a”	n
CODE
		1B	61	n
HEX
		Prints the current line and feeds the paper n lines (where n is
REMARKS
		between 1 and 127).
		Form feed
FUNCTION
		<FF>
CODE
		0C
HEX
		Feeds the paper to the top of the next page, according to the page
REMARKS
		length set by <ESC>“C” n or <ESC>“C”<0> n when memory switch
		1-2 is set to 0. If memory switch 1-2 is set to 1, the paper is fed 18 mm,
		cut fully, and then feed back 18 mm. The print position is at the left
		margin in both cases.
		Horizontal tab
FUNCTION
		<HT>
CODE
	09
HEX
		Moves the print position to the next horizontal tab stop. Ignored if
REMARKS
		there is no next horizontal tab stop on the current line.

STAR MODE

– 37 –