TABLE OF CONTENTS
SAFE INSTALLATION, USE AND SERVICE | 2 |
GENERAL SAFETY | |
TABLE OF CONTENTS | 5 |
INTRODUCTION | 5 |
Preparing for the Installation | 5 |
INSTALLATION REQUIREMENTS FOR THE |
|
COMMONWEALTH OF MASSACHUSETTS | 6 |
TYPICAL INSTALLATION | |
LOCATING THE NEW WATER HEATER | |
Facts to Consider About Location | |
Insulation Blankets | 10 |
Combustion Air and Ventilation for Appliances |
|
Located in Unconfined Spaces | 10 |
Combustion Air and Ventilation for Appliances |
|
Located in Confined Spaces | |
INSTALLING THE WATER HEATER | |
Chemical Vapor Corrosion | 12 |
Water Piping | |
Closed Water Systems | 12 |
Thermal Expansion | 12 |
13 | |
Gas Piping | 14 |
Sediment Traps (Drip Legs) | 15 |
Filling the Water Heater | 15 |
Venting | 15 |
Vent Pipe Termination | |
Planning the Vent System | |
Condensate | 17 |
Blower Assembly Installation | |
Installation of Vent System | |
Vent Pipe Preparation | |
LIGHTING & OPERATING LABEL | 23 |
TEMPERATURE REGULATION | 24 |
FOR YOUR INFORMATION | 25 |
Start Up Conditions |
|
Smoke/Odor | 25 |
Thermal Expansion | 25 |
Strange Sounds | 25 |
Operational Conditions | 25 |
Smelly Water | 25 |
“Air” in Hot Water Faucets | 25 |
High Temperature Shut Off System | 25 |
PERIODIC MAINTENANCE | |
Venting System Inspection | 26 |
Burner Operation and Inspection | 26 |
Burner Cleaning | 26 |
Housekeeping | |
Anode Rod Inspection | 27 |
27 | |
Draining | 27 |
Service | 28 |
LEAKAGE CHECKPOINTS | 28 |
REPAIR PARTS | 29 |
TROUBLESHOOTING | |
WARRANTY | 35 |
INTRODUCTION
Thank You for purchasing this water heater. Properly installed and maintained, it should give you years of trouble free service.
Abbreviations Found In This Instruction Manual:
•ANSI - American National Standards Institute
•NFPA - National Fire Protection Association
•ASME - American Society of Mechanical Engineers
•GAMA - Gas Appliance Manufacturer’s Association
•UL - Underwriters Laboratories Inc.
This
Preparing for the Installation
1.Read the “General Safety” section, page 3 and 4 of this manual first and then the entire manual carefully. If you don’t follow the safety rules, the water heater will not operate properly. It could cause
DEATH, SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE.
This manual contains instructions for the installation, operation, and maintenance of the
TO INSTALL OR OPERATE THE WATER HEATER.
2.The installation must conform with these instructions and the local code authority having jurisdiction. In the absence of local codes,
installations should comply with the National Fuel Gas Code (ANSI Z223.1/NFPA 54) and the National Electrical Code (NFPA 70). These publications are available from The National Fire Protection Association, 1 Batterymarch Park, Quincy, MA 02269.
3.The water heater when installed must be grounded in accordance with the local codes, or in the absence of local codes: the National Electrical Code (NFPA 70).
4.If after reading this manual you have any questions or do not understand any portion of the instructions, call the local gas utility or the manufacturer whose name appears on the rating plate.
5.Carefully plan the place where you are going to put the water heater. Correct combustion, vent action, and vent pipe installation are very important in preventing death from possible carbon monoxide poisoning and fires, see Figures 1 and 2.
Examine the location to ensure the water heater complies with the “Locating the New Water Heater” section in this manual.
6.For California installation this water heater must be braced, anchored, or strapped to avoid falling or moving during an earthquake. See instructions for correct installation procedures. Instructions may be obtained from California Office of the State Architect, 400 P Street, Sacramento, CA 95814.
7.Massachusetts Code requires this water heater to be installed in accordance with Massachusetts
8.Complies with SCAQMD rule #1146 and districts having equivalent NOx requirements.
5