English
Models with stardard starter
2 3
4 
KN217BA044
Models with Easy2Start
4
4 
KN217BA045
NUse a screwdriver or suitable pliers to remove the spring clip (2) from the starter post.
NCarefully remove the rope rotor with washer (3) and pawl (4).
The rewind spring may pop out and uncoil during this operation – take care to avoid risk of injury.
Replacing the starter rope
Models without ElastoStart and models with Easy2Start
NUse a screwdriver to pry the rope out of the starter grip.
NRemove the remaining rope from the rotor and starter grip.
36
151BA021 KN
NThread the new rope through the starter grip and tie one of the special knots shown.
NPull the knot back into the grip.
5 
217BA046 KN
NThread the rope through the top of the guide bushing (5).
NThread the rope through the rotor and secure it with a simple overhand knot.
7 
KN217BA047
NCoat rope rotor bearing bore with
NSlip the rotor (6) with carrier (7) over the starter post – turn it back and forth to engage the anchor loop of the rewind spring.
217BA048 KN
NThe spring under the carrier must engages the rope rotor and the carrier (arrows).
4
4 
KN217BA045
NFit the pawls (4) in the rotor and fit the washer (3) on the starter post.
NUse a screwdriver or suitable pliers to install the spring clip (2) on starter post and engage it on the pawls'
MS 192 T, MS 192 TC