English |
| |
|
| Chain scabbard |
Cutting Attachment |
| |
|
| |
|
|
|
Mounting the Bar and Chain
A cutting attachment consists of the saw chain, guide bar and chain sprocket.
The cutting attachment that comes standard is designed to exactly match the chain saw.
1 | 2 |
|
|
| |
| 3 | KN |
a | 001BA248 | |
|
|
–The pitch (t) of the saw chain (1), chain sprocket and the nose sprocket of the Rollomatic guide bar must match.
–The drive link gauge (2) of the saw chain (1) must match the groove width of the guide bar (3).
If
001BA244 KN
Your saw comes standard with a chain scabbard that matches the cutting attachment.
If you use guide bars of different lengths on the saw, the length of the chain scabbard must be matched to the guide bar to reduce the risk of injury. It should cover the full length of the guide bar.
The length of the matching guide bars is marked on the side of the chain scabbard.
Removing the chain sprocket cover
143BA034 KN |
NUnscrew the nuts and take off the chain sprocket cover.
| 1 |
2 | KN |
| 001BA185 |
NTurn the screw (1) counterclockwise until the tensioner slide (2) butts against the left end of the housing slot.
26 | MS 250 |
