WARNING
Depth gauges that are too low increase the kickback tendency of the chain saw.
689BA052 KN |
English
NAfter sharpening, clean the saw chain thoroughly, removing any filings or grinding dust – lubricate the saw chain thoroughly
NIn the event of extended periods of disuse, store saw chains in cleaned and oiled condition
NLay the file gauge on the saw chain
– the highest point of the depth gauge must be flush with the file gauge
Sharpening tools (special accessories) |
|
|
|
| ||||
Chain pitch | Round file ^ | Round file | File holder | File gauge | Taper square file | Sharpening set | ||
|
|
|
|
|
|
|
| 1) |
Inches | (mm) | mm | (Inches) | Part number | Part number | Part number | Part number | Part number |
1/4 P | (6.35) | 3.2 | (1/8) | 5605 771 3206 | 5605 750 4300 | 0000 893 4005 | 0814 252 3356 | 5605 007 1000 |
1/4 | (6.35) | 4.0 | (5/32) | 5605 772 4006 | 5605 750 4327 | 1110 893 4000 | 0814 252 3356 | 5605 007 1027 |
3/8 P | (9.32) | 4.0 | (5/32) | 5605 772 4006 | 5605 750 4327 | 1110 893 4000 | 0814 252 3356 | 5605 007 1027 |
0.325 | (8.25) | 4.8 | (3/16) | 5605 772 4806 | 5605 750 4328 | 1110 893 4000 | 0814 252 3356 | 5605 007 1028 |
3/8 | (9.32) | 5.2 | (13/64) | 5605 772 5206 | 5605 750 4329 | 1110 893 4000 | 0814 252 3356 | 5605 007 1029 |
0.404 | (10.26) | 5.5 | (7/32) | 5605 772 5506 | 5605 750 4330 | 1106 893 4000 | 0814 252 3356 | 5605 007 1030 |
1)consisting of file holder with round file, taper square file and file gauge
MS 250 | 49 |
