ASSEMBLY INSTRUCTIONS/OPERATIONS

FIGURE 3

6)Assemble the two each, hose clamps P/N 14821-012 over the PN 290018-093 vacuum hose. Install the vacuum hose over the vacuum hose attach fittings. Determine that the configuration minimizes potential kinks or depressions, which can reduce the airflow. Secure the hose clamps tight with the screwdriver.

7)The DFG-1000 Safety and Dust Shield Assembly Kit can be removed by reversing the above procedure and reinstalling the original bumper P/N 29018-016

8)Return the SURFACE GRINDER to its normal operating position.

9)If the SURFACE GRINDER is powered by a gasoline engine, reconnect the engine spark plug wire. If powered by an electric motor and the machine is to be used immediately, reconnect the extension cord or SURFACE GRINDER to the power source. Determine that the ON/OFF switch located on the operator handle is in the OFF position.

DANGER

UNEXPECTED MACHINE START UP CAN RESULT IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.

Before Starting the Engine

FILLING THE ENGINE CRANKCASE WITH OIL.

Applications: DFG/G SURFACE GRINDER.

Tools Required:

1 each, small, clean funnel.

The DFG/G Series SURFACE GRINDER is equipped with a Honda GX340 gasoline engine. This engine is normally not pre-serviced at the factory and will require the addition of oil in the crankcase before being placed in service. Consult the material supplied by the engine manufacturer for the engine that has been ordered with your SURFACE GRINDER. Carefully review this material to become familiar with specific operating characteristics, recommendations and service requirements.

1)Determine the location(s) of both the oil filler and oil drain plug(s).

2)Wipe oil, dust and accumulated dirt from the filler plug area.

3)Using the funnel, fill the engine crankcase with a high grade motor oil. Consult the material supplied by the engine manufacturer for proper amount, weight and service classification.

4)Replace the oil filler plug and tighten. Wipe off any excess oil spilled on the engine crankcase and SURFACE GRINDER.

5)Do not operate the engine unless proper oil level is maintained as per the material supplied by the engine manufacturer.

FILLING THE DFG/G SERIES ENGINE FUEL TANK.

Tools Required:

1 each, small, clean funnel.

CAUTION

Never mix oil with gasoline. Four cycle engines are not designed to be operated with oil mixed with the gasoline.

1)Determine the location of the fuel tank filler cap.

2)Carefully clean the filler cap and surrounding area to insure that no dirt or debris falls into the fuel tank. Remove the filler cap.

DFG-SERIES SURFACE GRINDERS

OPERATION AND PARTS MANUAL REV #3 (07/13/06)

PAGE 17

 

 

 

Page 17
Image 17
Stow DFG Series Before Starting the Engine, Filling the Engine Crankcase with OIL, Applications DFG/G Surface Grinder