ASSEMBLY INSTRUCTIONS/OPERATIONS
To maximize the service life of the diamond segments, it is recommended that the blades be rotated between gimbal heads a minimum of once for every 8 hours of operation.
FIGURE 22
Diamond Segment Block
The diamond insert block is designed to compliment the
Diamond segments are retained into a steel block assembly and deliver up to 5 times greater productivity rates than the silicon carbide stones. FIGURE 24. The design resists clogging while delivering a conservative service life up to 15 times longer than the stones. Diamond is the ideal choice for larger concrete removal projects and the removal of epoxies, paints and many thin film coatings.
FIGURE 23
The concept is especially useful for removing a thin layer of concrete in final preparation for a new coating application. Can be used in both wet and dry
job applications. Worn inserts are easily replaced in a matter of seconds. Service life is dependent upon many variables, but can approach 35,000 square feet per set, making it a cost efficient solution for many job applications.
FIGURE 24
INSTALLING A
Application: All Models. Tools Required:
1 each, Small Hammer Parts Required:
6 each, P/N
DANGER
WHEN INSTALLING A
1)If the SURFACE GRINDER is powered by an engine, disconnect the spark plug wire. If powered by an electric motor, properly disconnect the extension cord or SURFACE GRINDER from the power source.
2)Tilt the SURFACE GRINDER back until the operator handle comes in contact with the surface. The SURFACE GRINDER may not be in a stable position in this configuration. To minimize the possibility of property damage and/or personal injury, properly secure an
OPERATION AND PARTS MANUAL REV #3 (07/13/06) | PAGE 26 | |
|
|
|
