Enviro C-11253, C-11102, 50-1472 owner manual Kit Parts List, Conversion Kit Installation

Maintenance And Service

Kit Parts List:
1	- Orifice (Natural Gas #42 DMS or Propane #54 DMS)
1	- Conversion label	1 - Installation instruction sheet

Carefully inspect the orifice supplied with this conversion kit. If it has been damaged or is missing, contact your dealer, distributor or courier company to have them replaced before starting this installation.

Conversion Kit Installation:

1.Shut the gas supply off at the shut-off valve upstream of the unit. CAUTION: The gas supply must be shut off prior to disconnecting the electrical power and before proceeding with the conversion. Allow the valve and unit to cool down to room temperature.

2.Remove the glass door as shown in the MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.

3.Carefully remove the log set and ember material if they are installed.

4.Using a T-20 screwdriver, remove the four (4) screws that hold the burner in place (pointed out in Figure 21). Slide the burner to the left (see Figure 22), then up and out of the firebox.

5.Convert the burner orifice:

a)Remove the main burner orifice with a 1⁄2 inch deep socket (see Figure 23).

b)Put a bead of pipe-thread sealant or approved Teflon tape on the orifice threads before installing into the brass elbow.

c)Install the new orifice from the kit into the brass elbow (see Figure 24).

6.Convert the pilot:

a)Open the front of the pilot shield.

b)Using a 7/16” wrench, turn the pilot head a 1⁄4 turn counter-clockwise (shown in Figure 25).

c)Push the slider, with your finger or flat head screwdriver, to the left if it is to be set for natural gas or to the right for propane, red on the slider will be visible (see Figure 26).

Figure 21: Unfastening Burner.

Figure 22: Burner Removal.

Figure 23: Orifice Removal.	Figure 24: Orifice	Figure 25: Turn Pilot Head.
	Replacement.

15