Enviro C-11102, C-11253 Initial Installation, Qualified Installers Only, Electrical Requirements

Initial Installation

QUALIFIED INSTALLERS ONLY

ELECTRICAL REQUIREMENTS:

The fan will not operate if the appliance is cold. A few minutes after the appliance is lit and the fan is set to low or high, the fan will automatically turn on. The fan will automatically turn off after the appliance has cooled down.

		120oF (49oC)
Fan Control		Temperature Sensor
Low	High
CNT6	CNT8	CNT3	CNT2
		Black		Black
	CNT7
			CNT9
	Grey			Black
	Grey		White
			Green	Power Cord
				120V AC
		CNT5
	CNT4	CNT1
		FAN

Figure 44: Fan wiring diagram.

The fireplace must be electrically connected and grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electrical Code Part 1, Safety Standards For Electrical Installations, or The National Electrical Code ANSI / NFPA 70 in the US.

WARNING: The electrical grounding instructions must be followed. The fan kit is equipped with a three-prong (grounding) plug for your protection against shock hazard, and should be plugged directly into a properly grounded three-prong outlet. DO NOT cut or remove the grounding prong from this plug.

CAUTION: When servicing controls, label all wires prior to disconnection. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

Figure 45: Wiring of a valve.

25