Enviro C-11102, C-11253, 50-1472 Kit Contents Quantity Description, Vent Kit Installation

Initial Installation

QUALIFIED INSTALLERS ONLY

•Carefully clean the fireplace and flue before installing the stove. Failure to do so may result in fumes or dirt being blown into the room and may cause a fire leading to death or serious injury.

•If one or more Sonnets are to be installed, confirm that the remote control signal codes are different

for each unit, refer to MAINTENANCE AND SERVICE - CHANGING REMOTE HANDSET CODE.

1.Remove the unit from the box and remove all packaging material from the appliance.

2.Remove door. See MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.

3.Remove log and ember set and all wrapping material from the stove. Remove wrapping material from log and embers and check for any damage. If damage is observed, do not use unit and contact your local dealer.

4.Refractory, glass doors, screen rails, screen mesh and log grates can be removed from the fireplace before installing the Sonnet. Check that the chimney clean outs fit properly. The flue damper can be fully blocked open or removed for installation of the Sonnet; the smoke shelves, shields and baffles may be removed if attached by mechanical fasteners. IMPORTANT: Cutting any sheet-metal parts of a fireplace, in which the gas fireplace insert is to be installed, is prohibited.

5.If the fireplace opening is lower than 19” (483mm), remove the vent collar plate from the top of the insert by unscrewing the two (2) T-20 Torx screws located on the center top of the stove. Slide the collar plate backwards. Properly secure the vent collar plate to the flexible vent pipe liner(s) previously installed in the chimney. Be careful not to over-stretch the liner(s).

6.Place the unit part way into the fireplace. Connect the household gas line into the 3⁄8” NPT receptacle at the lower right rear of the unit using locally approved methods. Place the electric cable so it can be

connected to the power supply.

7. As you push the unit into its final position in the fireplace, if the vent collar plate was removed, reinstall it to the stove by sliding it along the draft hood and secure with the screws previously removed.

8. Using a 1⁄4” hex driver, adjust the levelling legs to ensure the unit is level and high enough if a base shelf and/or riser is to be installed. There are two

(2) levelling legs on each side (shown in Figure

31).

Figure 31: Levelling legs position.

CONVERTING A DIRECT VENT FIREPLACE TO A B-VENT FIREPLACE:

Kit Contents:

Quantity Description

1Air Intake Plug

1Spill Switch with Wires & Bracket

B-Vent Kit Installation:

Please ensure that all components are supplied with this kit. If components are missing or have been damaged, contact your dealer, distributor or courier company before starting this installation.

1.Install the air intake plug.

a)Place high temperature silicone on the outer surface of the ridges of the air intake plug (see Figure

32).

b)Slide the air intake plug into the air intake on the back of the unit.

19