Studer Innotec XTH 5000-24 Control and display parts for the Xtender b, Type plate elements b

STUDER Innotec						Xtender
Pos.	Denomination	Description				Comment
10	L1/L2/L3	Phase selection jumpers.				See chapter 6.3.1. – p.22.
						Jumper default at position L1
11	+BAT	Positive pole battery connection				Carefully read chapter 4.5 – p.12
		terminals				Take care with the polarity of the battery
12	-BAT	Negative	pole	battery		and when tightening the clamp.
		connection terminals
13	AC Input	Connection	terminals	for	the	See chapter 4.5.7 - p. 14.
		alternative	power	supply		Note: It is imperative that the PE terminal
		(generator or public network)				be connected.
14	AC Output	Connection	terminals	for	the	See chapter 4.5.6 - p. 14.
		device output.				Note: Increased voltages may appear on
						the terminals, even in the absence of
						voltage at the input of the inverter.

15 Control and display parts for the Xtender (fig. 4b)

See chapter 7.2 - p. 24.

Pos.	Denomin	Description				Comments
	ation
41	ON/OFF	ON/OFF button				The ON/OFF button allows the start up or complete stoppage
						of the system such as it has been programmed. When there
						are several units in the same system, each unit must be
						started up or stopped individually using this button.
42	OFF	Light	indicator			When the light indicator flashes it indicates the cause of the
		for stoppage			of	stoppage of the unit, its imminent stoppage or the limitation of
		the unit				its rated power output according to chapter 7.2 - p.24.
43	ON	Light	indicator			This indicator is glowing continuously when the device is
		showing that the				working. It flashes when the equipment is at a temporary
		equipment		is	in	stop. Note: The equipment will restart automatically when the
		operation				conditions that led to the temporary stoppage have gone
						away.
44	Charge	Light	indicator			This indicator is glowing continuously when the charger is in
		showing that the				operation and has not yet reached the absorption phase.
		battery	is	being		It flashes twice during the absorption phase and once during
		charged				the maintenance phase.
						If smart boost mode has been activated it is possible that this
						indicator will go out temporarily when source backup is
						required by users. (See chapter 6.2.6 - p. 19)
45	AC in	Light	indicator			This indicator is glowing continuously when an alternative
		showing			the	voltage with correct values is present at the AC IN input (13)
		presence			of	of the device and the current limit {1107) set by the user has
		correct		and		not been reached. It flashes when this limit is reached (see
		synchronised				chapter 6.2.5 – p. 19).
		input voltage
46	AC out	Light	indicator			This indicator is glowing continuously when an alternative
		showing			the	voltage of 230V is present at the device output. It flashes
		presence		of	a	when the device is in “load search” mode due to the absence
		voltage	at		the	of users. (See chapter 6.2.3 – p. 16)
		output

16 Type plate elements (fig. 1b)

Pos.	Denomination	Description		Comments
31	Model	Model
32	Pnom/P30	Rated power output / power for 30 minutes
Installation and operating Instructions			Xtender V1.3	Page 32