Studer Innotec XTH 8000-48, XTH 6000-48, XTH 5000-24 Conventions, Quality and warranty

STUDER Innotec Xtender

2.2 Conventions

This symbol is used to indicate the presence of a dangerous voltage that is sufficient to constitute a risk of electric shock.

This symbol is used to indicate a risk of material damage.

This symbol is used to indicate information that is important or which serves to optimise your system.

All values mentioned hereafter, followed by a configuration no. indicate that this value may be modified with the help of the RCC-02/03 remote control.

In general, the default values are not mentioned and are replaced by a configuration no. in the following format: {xxxx}. The default values for this configuration are specified in the configuration table, p. 34.

All configuration values modified by the operator or installer must be transferred into the same table. If a parameter not appearing in the list (advanced configurations) has been modified by an authorised person with technical knowledge, they will indicate the number of the modified parameter(s), the specifications of the configuration(s) and the new value set, at the end of the same table.

All figures and letters indicated in brackets refer to items of figures in the separate manual “Appendix to the installation and operating instructions” supplied with the device.

The figures in brackets refer to elements belonging to the Xtender. The uppercase letters in brackets refer to AC cabling elements. The lowercase letters in brackets refer to battery cabling elements.

2.3 Quality and warranty

During the production and assembly of the Xtender, each unit undergoes several checks and tests. These are carried out with strict adherence to the established procedures. Each Xtender has a serial number allowing complete follow-up on the checks, according to the particular data for each device. For this reason it is very important never to remove the type plate (appendix I – fig. 3b) which shows the serial number. The manufacture, assembly and tests for each Xtender are carried out in their entirety by our factory in Sion (CH). The warranty for this equipment depends upon the strict application of the instructions appearing in this manual.

The warranty period for the Xtender is 2 years.

2.3.1EXCLUSION OF WARRANTY

No warranty claims will be accepted for damage resulting from handling, usage or processing that does not explicitly appear in this manual. Cases of damage arising from the following causes are notably excluded from the warranty:

•Surge voltage on the battery input (for example, 48 V on the battery input of an XTH 3000- 12)

•Incorrect polarity of the battery

•The accidental ingress of liquids into the device or oxidation resulting from condensation

•Damage resulting from falls or mechanical shocks

•Modifications carried out without the explicit authorisation of Studer Innotec

•Nuts or screws that have not been tightened sufficiently during the installation or maintenance

•Damage due to atmospheric surge voltage (lightning)

•Damage due to inappropriate transportation or packaging

•Disappearance of original marking elements

Installation and operating Instructions Xtender V1.3 Page 4