Sub-Zero Convection Microwave Oven manual F R E E - S Ta N D I N G, B U I Lt- I N

W O L F C O N V E C T I O N M I C RO WAV E INSTALLATION

UNPACKING YO U R M I C RO WAV E		CHOOSING A L O C AT I O N
	Remove all packing materials from inside	F R E E - S TA N D I N G
	the oven cavity; however, Do not remove	You will use the oven frequently so plan its
	the waveguide cover, which is located on
		location for ease of use. It’s wise, if possible, to
	the top of the cavity, see illustration below.
		have counter space on at least one side of the
	Read enclosures and save this Use and
		oven. Allow at least two inches (5 cm) on the
	Care Information for future reference.
		sides, top and at the rear of the oven for air
	Remove the feature sticker (if there is one),
		circulation.
	from the outside of the door.
	Check the oven for any damage, such as	B U I LT- I N
	misaligned or bent door, damaged door	Your microwave oven can be built into a
	seals and sealing surfaces, broken or loose
		cabinet or wall by itself or can be used above
	door hinges and latches and dents inside
		any Wolf electric built-in oven.
	the cavity or on the door. If there is any
	damage, do not operate the oven and	Refer to the installation instructions in both the
	contact your dealer or Wolf authorized	built-in oven and Wolf’s Convection Microwave
	service center.	Trim Kit. Do not install above any other gas
		or electric built-in oven. The trim kit includes
		finish trim strips, ducts, installation instruc-
		tions and information on the location of the
		power supply. To request the trim kit, contact
		your dealer. Be certain to check the local
		building code as it may require the opening be
		enclosed with sides, ceiling and rear partition.
		The proper functioning of the oven does not
		require the enclosure.

Hinges Waveguide cover

Safety door latches

Door seals and sealing surfaces

10