Sunbeam EM6200 manual Steam Wetness or Steam Pump Rate, Advanced programming options continued

Models: EM6200

1 40
Download 40 pages 6.05 Kb
Page 34
Image 34
Steam Wetness or Steam Pump Rate

Advanced programming options (continued)

Steam Wetness or Steam Pump Rate

The steam pump rate of this espresso machine has been preset. Modifying the steam pump rate enables you to make the steam wetter or dryer and aids in the delivery of a powerful, dry steam - ideal for texturing milk. The steam pump rate can be modified in flow rate increments up or down should it be desired.

To do this you need to follow the instructions below:

1.Insert the power cord into a 230-240V AC power outlet and switch the power ‘ON’.

Note: Although the espresso machine is ON at the power outlet ensure that the actual espresso machine power is ‘OFF’. Therefore no lights will be illuminated on the espresso machine control panel.

2.Press and hold down both the ‘MANUAL’ and ‘HOT WATER/STEAM’ buttons.

3.While still holding down the ‘MANUAL’ and ‘HOT WATER/STEAM’ buttons briefly press the ‘POWER’ button and release all buttons.

Note: This activates the programmability of the Steam Pump Rate and to signal this a series of beeps will follow and the ‘MANUAL’ and ‘HOT WATER/STEAM’ button LEDS will light up. Additionally the ‘SINGLE’ and ‘DOUBLE’ button LEDS will start to flash.

Note: A series of beeps will indicate the current setting.

4.Press the ‘SINGLE’ button to decrease to decrease the steam pump rate or to increase the steam rate press the ‘DOUBLE’ button. Please refer to the chart below.

Steam Pump Rate Programming

Setting

Beep Sequence

 

 

 

+3 (Factory Setting)

3

Short Beeps

 

 

 

+2

2

Short Beeps

 

 

 

+1

1

Short Beep

01 Short Beep and 1 Long Beep

-1

1

Long Beep

 

 

 

-2

2

Long Beeps

 

 

 

-3

3

Long Beeps

5.Once you have selected the desired steam pump rate, press and hold both the ‘MANUAL’ and ‘HOT WATER/STEAM’ buttons to save the new setting. A single long beep will sound to indicate the setting has been saved. The espresso machine will then turn on to ‘READY MODE’.

Remember: If you do not press the ‘MANUAL’ and ‘HOT WATER/STEAM’ buttons within

30 seconds the program will return to the Factory Setting and the espresso machine will then power on and begin heating up.

32

Page 34
Image 34
Sunbeam EM6200 manual Steam Wetness or Steam Pump Rate, Advanced programming options continued, Steam Pump Rate Programming