Using the control panel (continued)
Programming the Single or Double pours
The program function allows the coffee maker to personalise and save their own espresso pour settings.
To program the ‘SINGLE’ and ‘DOUBLE’ coffee pours the espresso machine needs to be in STAND BY MODE (so the machine is plugged in and turned on at the wall, but the power on the machine has not yet been turned on).
To activate the program function for the ‘SINGLE’ and ‘DOUBLE’ espresso pours, the coffee maker needs to press and hold down both the ‘SINGLE’ and ‘DOUBLE’ buttons. While still holding down these two buttons briefly press the ‘POWER’ button and release all buttons. When in programming mode the lights around the ‘SINGLE’ and ‘DOUBLE’ buttons will slowly flash (dimming up and down).
Depending on which pour you want to program, press either the ‘SINGLE’ or ‘DOUBLE’ espresso pour buttons, upon release the pour will begin.
Note: For best results the coffee make should only make changes to the ‘SINGLE’ and ‘DOUBLE’ coffee pour volumes by engaging the coffee handle fitted with either the single or double basket, packed with coffee.
When the desired pour amount has been reached press the flashing coffee button to set the new volume. A long beep will sound confirming the program saved and the machine will go into ‘READY MODE’.
Note: For more detailed information on programming refer to page 17 ‘Programming your espresso machine’.
Steam
The steam function allows the coffee maker to produce steam out of the steam wand for texturing milk.
To activate the steam function, the coffee maker simply needs to press the ‘STEAM’ button. By design the temperature of the espresso machine will adjust as necessary. There may be a short delay while you wait.
Note: When the coffee maker has activated the steam function the light around the ‘STEAM’ button will show a constant red light and the light behind the ‘MANUAL’, ‘SINGLE’ and ‘DOUBLE’ buttons will go off. Additionally the light on the ‘POWER’ button will remain on.
Note: If the light behind the ‘STEAM’ button is flashing it means the espresso machine is adjusting the temperature of the heating system. You will be able to use the steam while it is heating up but this is not advised as the steam will be wetter than if the machine is fully heated up.
Once the espresso machine is heated to the correct temperature, so the light behind the ‘STEAM’ button stops flashing and shows a constant red light, the coffee maker is able to use the espresso machine.
The coffee maker simply needs to turn the steam and hot water control dial anti- clockwise to the ‘MAX’ setting to start and turn it back to the ‘OFF’ position to stop. Press the 'STEAM' button again to deactivate the steam function.
Note: When you have finished steaming, ensure the steam and hot water control dial is fully turned off. If the steam and hot water control dial is left open, the coffee maker will not be able to switch to the ‘COFFEE’ or ‘HOT WATER’ functions.
10
