Sunbeam HG6600 manual Using your Sunbeam Kettle King, Before first use, Using your Kettle King

Using your Sunbeam Kettle King.

Before first use.

Remove any stickers from the hotplate. Wash the hotplate and drip tray in warm soapy water using a mild household detergent. Dry hotplate and drip tray thoroughly.

To assemble the stand. (HG6600 only)

Place the base of the stand on a flat level surface. With the slots to the bottom, insert the metal tube into the hole in the centre of the base and push down firmly.

Place the swivel shelf over the metal tube with the handle on your left. Slide the shelf down the metal tube until it rests on the two plastic pins as indicated in Figure 1. Never attempt to remove the plastic pins from the metal tube, as these are the locators for the swivel shelf.

Place the top shelf onto the metal tube with the utensil rack facing away from you and align it with the swivel shelf. Push down firmly in the centre of the top shelf to secure it.

Place the base of the Kettle King on the top shelf and fit it into position. The base is correctly positioned when it is flush with the top shelf of the stand on all sides.

Place drip tray into base. For easy cleaning line the drip tray with aluminium foil. This will collect the fats and juices.

Position the hotplate over base and drip tray, as shown in Figure 1.

For better non-stick performance, “season” the cooking surface of the hotplate by applying a thin coat of cooking oil and rubbing in with paper towelling before each use.

WARNING: Charcoal or similar combustible fuels must not be used with this appliance.

NOTE: Do not place any objects such as saucepans or plates on the hotplate.

Using your Kettle King.

1.Insert the Control Probe fully into the socket of the hotplate.

2.Plug the cord into a 230/240V power outlet and turn the power on. An extension cord that has been checked and tested by your electricity supplier or a qualified technician may be used with your Kettle King.

3.Set the control probe dial to the desired heat setting.

Remove the lid from the Kettle King and allow to heat up. When the thermostat light on the control probe switches off, the desired cooking temperature has been reached and the Kettle King is ready to use.

For oven style cooking, set the dial to Roast setting, replace the lid and pre-heat for approximately 10 minutes.

Note: The thermostat light on the control probe indicates the Kettle King is heating. This light will remain ON until the set temperature has been reached and then will cycle ON and OFF throughout cooking. This will ensure that the Kettle King always maintains the selected temperature. The pre-heat time will depend on the heat setting selected.

4