Section 4
Disassembly/Reassembly, and Adjustment
Step 1 - Controller and Seat
Note: When using the terms “Right Hand, Left Hand” this is referenced as if seated in the chair.
Disassembly
a.Squeeze down the locking legs of the 3 pin charger plug and unplug it from the rear of the chair. (figure s1.1).
b.Rock the controller plug back and forth until it is loose and then unplug it (figure s1.1).
Note: Remember to lay cables on the seat otherwise they may become tangled when taking off the seat.
c.Pull out the safety pin from the left front seat post (figure s1.2).
d.Tilt the seat back, slide it forward, and lift it off of the base (figure s1.2).
Reassembly
a.Line up the rear seat frame with the rear seat posts, slide the seat back to the stops and let the seat frame rotate down in to the front seat post latching brackets.
b.Make sure the latching levers are locked flat against the seat post brackets, and insert the locking pin.
c.Plug the controller plugs into the plug receptacles at the rear of the chair.
Adjustment
Note: There is a setscrew in each “saddle” of the front seat post brackets that can adjust the free play of the seat frame in the bracket. Adjustment of this part is accomplished by using a 3 mm Hex wrench. After adjustment, ensure that the latching levers are fully seated and the locking pin can be installed see (figure s1.3).
s1.1
s1.2
s1.3
SUNRISE MEDICAL | ASPIRE SERVICE MANUAL | 2003 | PAGE 11 |
