Safety warnings and user tips
WARNING
Fasteners
•Many of the screws and bolts on this chair are special
•Many nuts are of the Nyloc type. Nylocs are single use fasteners and must be replaced when removed. They have a plastic insert to help prevent loosening.
•Only use screws, bolts and nuts provided by Sunrise.
1.Use of improper fasteners may cause the chair to fail.
2.Over or
3.If bolts or screws become loose, tighten them as soon as you can. Loose bolts or screws can cause damage to other chair parts causing them to fail.
Washers and Spacers
•Note the position of washers and spacers before disassembly.
•To avoid damage to the frame, replace all washers and spacers when you reassemble parts.
Torque Settings
•A torque setting is the optimal tightening for a particular fastener. Use a torque wrench to secure screws, nuts and bolts on this chair.
NOTE: Unless otherwise noted, use a torque setting of 13.5Nm for all fasteners.
WARNING
Speciality Controls
•Any specialist controls may have a detrimental effect on stability. We strongly recommend you apply caution when negotiating slopes and inclines.
WARNING
User injury could occur when allowing 3rd party individuals to gain access to the control system.
WARNING
Speciality control programming must only be preformed by an Authorised Sunrise Dealer.
WARNING
Be aware that latch drive can be dangerous when using speciality controls, please review the manual that comes with your product for correct use.
9 | Issue 7 |
|
|
